1/28 câu đang cập nhật đáp án (ghi rõ ở từng câu), chưa tính điểm; điểm tính trên 27 câu còn lại.
Xem trước: đọc nhanh mọi câu dạng chữ, chưa tính giờ, chưa hiện đáp án. Luyện tập: chọn đáp án là biết đúng sai ngay, kèm lời giải. Thi thử: nộp bài mới chấm điểm và hiện lời giải.
Câu 1
. As engine rpm increases, the ignition timing must:
Đáp án và lời giải
Đáp án: C
Câu 2
As engine rpm increases, the ignition timing must:
Đáp án và lời giải
Đáp án: B
Câu 3
Which of the following components generates a timing signal for the ignition system?
Đáp án và lời giải
Đáp án: B
Câu 4
All of the following components are part of a Distributorless Ignition System (DIS) EXCEPT:
Đáp án và lời giải
Đáp án: C
Câu 5
.The HEAT RANGE of a spark plug can be determined by:
Đáp án và lời giải
Đáp án: A
Câu 6
Which of the following components multiplies battery voltage to create a spark?
Đáp án và lời giải
Đáp án: D
Câu 7
.Which of the following can cause changes in Ignition Timing?
Đáp án và lời giải
Đáp án: D
Câu 8
.If the Crankshaft Position Sensor is not producing a signal, what will happen?
Đáp án và lời giải
Đáp án: C
Câu 9
An eight cylinder engine running at 3000 rpm requires sparks per SECOND.
Đáp án và lời giải
Đáp án: C
Câu 10
In an alternator, alternating current is converted to direct current by the:
Đáp án và lời giải
Đáp án: C
Câu 11
.CDI stands for:
Đáp án và lời giải
Đáp án: D
Câu 12
.A battery that is overcharged can be due to:
Đáp án và lời giải
Đáp án: D
Câu 13
Why is a thermistor used in an alternator regulator?
Đáp án và lời giải
Đáp án: B
Câu 14
.What does EMF stand for?
Đáp án và lời giải
Đáp án: A
Câu 15
Most vehicles today use the type of ignition system.
Đáp án và lời giải
Đáp án: A
Câu 16
.The type of ignition system in which two cylinders share one coil is called a:
Đáp án và lời giải
Đáp án: C
Câu 17
In an alternator, which component controls the output?
Đáp án và lời giải
Đáp án: D
Câu 18
Phương án trong đề gốc bị lỗi, đang sửa
.The basic purpose of the overrunning clutch in the starter drive is to:
Adisengage the armature when the engine starts
Bassist the solenoid during cranking.
Ckeep the hold-in winding energized during cranking
Dpull the starter pinion gear out of mesh
Epush-in and hold-out
Fpush-in and pull-out.
Gpull-in and hold-in
Hpull-in and push-out
It increase voltage
both a and b
It distributes high tension current to spark plug at correct time
None of the above
Câu này chưa tính điểm. Đáp án sẽ được cập nhật sớm.
Câu 19
In Magneto Ignition system
Đáp án và lời giải
Đáp án: C
Câu 20
.The following is known as ‘Breakerless Ignition system’
Đáp án và lời giải
Đáp án: B
Câu 21
The discharged lead acid battery has on its plates
Đáp án và lời giải
Đáp án: D
Câu 22
The main task of a battery in automobiles is to
Đáp án và lời giải
Đáp án: D
Câu 23
.During charging the specific gravity of the electrolyte of a lead acid battery
Đáp án và lời giải
Đáp án: D
Câu 24
Which component produces the electricity to charge the battery?
Đáp án và lời giải
Đáp án: B
Câu 25
.Which component uses the most amperage in a vehicle?
Đáp án và lời giải
Đáp án: A
Câu 26
What part of a car produces the electricity?
Đáp án và lời giải
Đáp án: C
Câu 27
.SV A nói trong đánh lửa trực tiếp bobine đôi, bougie nào ở kỳ nén sẽ có lửa. SV B nói 2 đầu dây cao áp của bôbine phải nối vào 2 bougie của 2 máy song hành. Ai đúng?
Đáp án và lời giải
Đáp án: B
Câu 28
Các câu dưới về định luật Pashen đều đúng, ngoại trừ: